EN AW-5083 vs EN AW-5052: 49% composition overlap. Significantly different materials serving different application areas.
EN AW-5083 vs EN AW-5052
Side-by-side chemical composition and mechanical property comparison.
Overview
EN AW-5083
3.3547
The highest-strength non-heat-treatable aluminium alloy. Excellent corrosion resistance (especially seawater), good weldability. Standard alloy for shipbuilding, offshore, pressure vessels, cryogenic applications, and armour plate. Not for continuous service above 65°C under stress (SCC risk).
EN AW-5052
EN AW-5052
General-purpose Al-Mg alloy — Mg 2.2-2.8%. Good balance of formability, corrosion resistance, and moderate strength (UTS 210-260 H32). Non-heat-treatable — strengthened by cold work. THE most widely used 5xxx alloy globally by tonnage. Used for sheet metal work, fuel tanks, marine components, appliances, lighting, and general fabrication. Excellent weldability.
| EN AW-5083 | EN AW-5052 | |
|---|---|---|
| Material Number | 3.3547 | EN AW-5052 |
| Category | Aluminum | Aluminum |
| Standard | EN 573-3 | EN 573-3 |
Chemical composition (wt%)
| Element | EN AW-5083 | EN AW-5052 | Overlap |
|---|---|---|---|
| Si | 0–0.4% | 0–0.25% | OK |
| Mn | 0.4–1% | — | — |
| Cr | 0.05–0.25% | 0.15–0.35% | Partial |
| Cu | 0–0.1% | — | — |
Mechanical properties
| Property | EN AW-5083 | EN AW-5052 | Unit |
|---|---|---|---|
| tensile_strength | 275–350 | 210–260 | MPa |
| yield_strength | ≥ 125 | 160–210 | MPa |
| elongation | ≥ 12 | 7–12 | % |
Compatibility Assessment
EN AW-5083 and EN AW-5052 have significantly different compositions (49% overlap). These materials are not interchangeable and serve different application areas.
Automated assessment based on composition analysis
Frequently Asked Questions
Is EN AW-5083 the same as EN AW-5052?
EN AW-5083 and EN AW-5052 have a 49% composition overlap. They are generally not directly interchangeable.
Can I replace EN AW-5083 with EN AW-5052?
Generally not recommended. The compositions differ significantly (49% overlap). These materials have different alloying concepts and are intended for different applications.
What is the difference between EN AW-5083 and EN AW-5052?
The main differences are in the following elements: Cr, Mg. EN AW-5083 is a Aluminum grade, while EN AW-5052 is a Aluminum grade.
Related Comparisons
View full data for each material:
Data provided for reference only. Always verify against the applicable specification for critical applications.
All data is for reference only. Equivalents indicate similarity, not identity. Always verify against the applicable specification for safety-critical applications. materialref.com accepts no liability for decisions based on this data.