EN AW-6061 vs EN AW-7075: 29% composition overlap. Significantly different materials serving different application areas.
EN AW-6061 vs EN AW-7075
Side-by-side chemical composition and mechanical property comparison.
Overview
EN AW-6061
3.3211
The most widely used aluminium alloy in North America. Good balance of strength, corrosion resistance, and machinability. Heat treatable (T6). Used for structural components, automotive parts, marine fittings, bicycle frames, and general engineering. Being replaced by 6082 in European applications.
EN AW-7075
3.4365
THE aerospace aluminum — Al-Zn5.6-Mg-Cu precipitation-hardened to the highest strength of any common aluminum alloy. T6 strength rivaling mild steel at 1/3 the density. Poor weldability and corrosion resistance vs 5xxx/6xxx. Used for aircraft wing skins, fuselage frames, high-stress structural components, and competitive cycling/climbing equipment. Often Alclad for corrosion protection.
| EN AW-6061 | EN AW-7075 | |
|---|---|---|
| Material Number | 3.3211 | 3.4365 |
| Category | Aluminum | Aluminum |
| Standard | EN 573-3 | EN 485-2 |
Chemical composition (wt%)
| Element | EN AW-6061 | EN AW-7075 | Overlap |
|---|---|---|---|
| Si | 0.4–0.8% | 0–0.4% | Partial |
| Mn | 0–0.15% | 0–0.3% | OK |
| Cr | 0.04–0.35% | 0.18–0.28% | OK |
| Cu | 0.15–0.4% | 1.2–2% | No overlap |
Mechanical properties
| Property | EN AW-6061 | EN AW-7075 | Unit |
|---|---|---|---|
| tensile_strength | ≥ 290 | 540–570 | MPa |
| yield_strength | ≥ 240 | 470–505 | MPa |
| elongation | ≥ 8 | 7–11 | % |
Compatibility Assessment
EN AW-6061 and EN AW-7075 have significantly different compositions (29% overlap). These materials are not interchangeable and serve different application areas.
Automated assessment based on composition analysis
Frequently Asked Questions
Is EN AW-6061 the same as EN AW-7075?
EN AW-6061 and EN AW-7075 have a 29% composition overlap. They are generally not directly interchangeable.
Can I replace EN AW-6061 with EN AW-7075?
Generally not recommended. The compositions differ significantly (29% overlap). These materials have different alloying concepts and are intended for different applications.
What is the difference between EN AW-6061 and EN AW-7075?
The main differences are in the following elements: Si, Cu, Mg, Zn. EN AW-6061 is a Aluminum grade, while EN AW-7075 is a Aluminum grade.
Related Comparisons
View full data for each material:
Data provided for reference only. Always verify against the applicable specification for critical applications.
All data is for reference only. Equivalents indicate similarity, not identity. Always verify against the applicable specification for safety-critical applications. materialref.com accepts no liability for decisions based on this data.