9SMnPb28 vs S355NL: 40% composition overlap. Significantly different materials serving different application areas.
9SMnPb28 vs S355NL
Side-by-side chemical composition and mechanical property comparison.
Overview
9SMnPb28
1.0718
Leaded free-cutting steel — Pb (0.15-0.35%) + S (0.24-0.33%) for maximum machinability. THE ultimate Automatenstahl: machinability rating ~175% (vs 100% for 11SMn30). Pb acts as chip-breaker and tool lubricant. Used for high-speed automatic screw machine production of screws, nuts, fittings, bushings, and any part where surface finish and cycle time matter most. NOTE: Pb content being phased out under EU ELV/RoHS — replacement grades emerging.
S355NL
1.0546
Normalized fine-grain structural steel with 355 MPa yield and -50°C impact toughness. The most widely used fine-grain grade in EN 10025-3. Workhorse for offshore, bridges, cranes, and wind turbine towers in cold climates. Better low-temp toughness than S355J2.
| 9SMnPb28 | S355NL | |
|---|---|---|
| Material Number | 1.0718 | 1.0546 |
| Category | Carbon Steel | Carbon Steel |
| Standard | EN 10087 | EN 10025-3 |
Chemical composition (wt%)
| Element | 9SMnPb28 | S355NL | Overlap |
|---|---|---|---|
| C | 0–0.14% | 0–0.18% | OK |
| Si | — | 0–0.5% | — |
| Mn | 0.9–1.3% | 1–1.65% | Partial |
| P | 0–0.06% | 0–0.025% | OK |
Mechanical properties
| Property | 9SMnPb28 | S355NL | Unit |
|---|---|---|---|
| tensile_strength | 370–500 | 470–630 | MPa |
| yield_strength | 230–300 | ≥ 355 | MPa |
| elongation | 14–22 | ≥ 22 | % |
Compatibility Assessment
9SMnPb28 and S355NL have significantly different compositions (40% overlap). These materials are not interchangeable and serve different application areas.
Automated assessment based on composition analysis
Frequently Asked Questions
Is 9SMnPb28 the same as S355NL?
9SMnPb28 and S355NL have a 40% composition overlap. They are generally not directly interchangeable.
Can I replace 9SMnPb28 with S355NL?
Generally not recommended. The compositions differ significantly (40% overlap). These materials have different alloying concepts and are intended for different applications.
What is the difference between 9SMnPb28 and S355NL?
The main differences are in the following elements: Mn, S. 9SMnPb28 is a Carbon Steel grade, while S355NL is a Carbon Steel grade.
Related Comparisons
View full data for each material:
Data provided for reference only. Always verify against the applicable specification for critical applications.
All data is for reference only. Equivalents indicate similarity, not identity. Always verify against the applicable specification for safety-critical applications. materialref.com accepts no liability for decisions based on this data.