PA12 (Nylon 12) vs PPS (unfilled): 0% composition overlap. Significantly different materials serving different application areas.
PA12 (Nylon 12) vs PPS (unfilled)
Side-by-side chemical composition and mechanical property comparison.
Overview
PA12 (Nylon 12)
Polyamide 12 — the long-chain polyamide with the lowest moisture absorption of all PA grades (0.1-0.15% vs PA6: 1.5%). Excellent dimensional stability in humid environments. Best chemical resistance among polyamides (oils, fuels, hydraulic fluids). Lowest density of all PA (1.01 g/cm³). Also the dominant 3D printing (SLS/MJF) material. Trade names include Rilsamid (Arkema), Grilamid L (EMS), TECAMID 12 (Ensinger), Vestamid L (Evonik). Used for fuel lines, brake lines, pneumatic tubing, cable sheathing, and 3D-printed functional parts.
PPS (unfilled)
Polyphenylene Sulfide — semi-crystalline high-performance thermoplastic. Broadest chemical resistance of any engineering plastic — no known solvents below 200°C. Inherently flame-resistant (V-0 without additives, LOI 44%). Very low moisture absorption (<0.02%). Brittle in unfilled form — usually glass-fiber reinforced for structural use. Trade names include Ryton (Solvay), Fortron (Celanese), Torelina (Toray), Durafide (Polyplastics). Used for chemical pump components, filter bags, electrical insulation, and as base resin for GF40 compounds.
| PA12 (Nylon 12) | PPS (unfilled) | |
|---|---|---|
| Material Number | — | — |
| Category | Polymers | Polymers |
| Standard | ISO 10350 | ISO 10350 |
Mechanical properties
| Property | PA12 (Nylon 12) | PPS (unfilled) | Unit |
|---|---|---|---|
| tensile_strength | 45–60 | 65–85 | MPa |
| yield_strength | 40–50 | — | MPa |
| elongation | 100–300 | 3–6 | % |
Compatibility Assessment
PA12 (Nylon 12) and PPS (unfilled) have significantly different compositions (0% overlap). These materials are not interchangeable and serve different application areas.
Automated assessment based on composition analysis
Frequently Asked Questions
Is PA12 (Nylon 12) the same as PPS (unfilled)?
PA12 (Nylon 12) and PPS (unfilled) have a 0% composition overlap. They are generally not directly interchangeable.
Can I replace PA12 (Nylon 12) with PPS (unfilled)?
Generally not recommended. The compositions differ significantly (0% overlap). These materials have different alloying concepts and are intended for different applications.
What is the difference between PA12 (Nylon 12) and PPS (unfilled)?
The main differences are in the following elements: overall alloying content. PA12 (Nylon 12) is a Polymers grade, while PPS (unfilled) is a Polymers grade.
Related Comparisons
View full data for each material:
Data provided for reference only. Always verify against the applicable specification for critical applications.
All data is for reference only. Equivalents indicate similarity, not identity. Always verify against the applicable specification for safety-critical applications. materialref.com accepts no liability for decisions based on this data.