FR-4 (Glass Epoxy Laminate) vs PA6-GF15: 0% composition overlap. Significantly different materials serving different application areas.
FR-4 (Glass Epoxy Laminate) vs PA6-GF15
Side-by-side chemical composition and mechanical property comparison.
Overview
FR-4 (Glass Epoxy Laminate)
Flame retardant woven fiberglass cloth with epoxy resin binder — the worldwide standard substrate material for printed circuit boards (PCBs). Designated NEMA grade FR-4 and IPC-4101. Good mechanical strength, dimensional stability and electrical insulation up to 130°C (Tg). Dielectric constant 4.2–4.7 at 1 MHz. Self-extinguishing (UL94 V-0). Used for single/multilayer PCBs, electrical insulation boards, structural composites in electronics, test fixtures and jigs. Available in thicknesses 0.1–50 mm.
PA6-GF15
Polyamide 6 with 15% short glass fiber reinforcement — moderate stiffness increase (E-Mod ~5.5 GPa vs 2.7 unfilled) while retaining good impact strength and elongation. Better toughness than higher-filled grades (GF30, GF50). Trade names: Ultramid B3EG3 (BASF), Zytel 73G15 (DuPont). Used for structural clips, housings, brackets, and under-hood automotive parts where moderate stiffness with good impact is needed.
| FR-4 (Glass Epoxy Laminate) | PA6-GF15 | |
|---|---|---|
| Material Number | — | — |
| Category | Polymers | Polymers |
| Standard | IPC-4101 | ISO 527-1 |
Mechanical properties
| Property | FR-4 (Glass Epoxy Laminate) | PA6-GF15 | Unit |
|---|---|---|---|
| Flexural Strength | 380–480 | — | MPa |
| Tensile Strength | 280–340 | — | MPa |
| Compressive Strength | 350–420 | — | MPa |
Compatibility Assessment
FR-4 (Glass Epoxy Laminate) and PA6-GF15 have significantly different compositions (0% overlap). These materials are not interchangeable and serve different application areas.
Automated assessment based on composition analysis
Frequently Asked Questions
Is FR-4 (Glass Epoxy Laminate) the same as PA6-GF15?
FR-4 (Glass Epoxy Laminate) and PA6-GF15 have a 0% composition overlap. They are generally not directly interchangeable.
Can I replace FR-4 (Glass Epoxy Laminate) with PA6-GF15?
Generally not recommended. The compositions differ significantly (0% overlap). These materials have different alloying concepts and are intended for different applications.
What is the difference between FR-4 (Glass Epoxy Laminate) and PA6-GF15?
The main differences are in the following elements: overall alloying content. FR-4 (Glass Epoxy Laminate) is a Polymers grade, while PA6-GF15 is a Polymers grade.
View full data for each material:
Data provided for reference only. Always verify against the applicable specification for critical applications.
All data is for reference only. Equivalents indicate similarity, not identity. Always verify against the applicable specification for safety-critical applications. materialref.com accepts no liability for decisions based on this data.