FR-4 (Glass Epoxy Laminate) vs PEEK GF30: 0% composition overlap. Significantly different materials serving different application areas.
FR-4 (Glass Epoxy Laminate) vs PEEK GF30
Side-by-side chemical composition and mechanical property comparison.
Overview
FR-4 (Glass Epoxy Laminate)
Flame retardant woven fiberglass cloth with epoxy resin binder — the worldwide standard substrate material for printed circuit boards (PCBs). Designated NEMA grade FR-4 and IPC-4101. Good mechanical strength, dimensional stability and electrical insulation up to 130°C (Tg). Dielectric constant 4.2–4.7 at 1 MHz. Self-extinguishing (UL94 V-0). Used for single/multilayer PCBs, electrical insulation boards, structural composites in electronics, test fixtures and jigs. Available in thicknesses 0.1–50 mm.
PEEK GF30
PEEK with 30% short glass fiber reinforcement. Dramatically increased stiffness (E-Mod 11 GPa vs 4.1 unfilled) and strength (UTS 160 vs 100 MPa) with reduced elongation and creep. Maintains PEEK's chemical resistance and high-temp capability (continuous 250°C). Trade names: Victrex 450GL30, TECAPEEK GF30 (Ensinger), KetaSpire GF30 (Solvay). Used for structural brackets, pump housings, valve seats, bearing cages, and semiconductor wafer handling where higher stiffness than unfilled PEEK is needed.
| FR-4 (Glass Epoxy Laminate) | PEEK GF30 | |
|---|---|---|
| Material Number | — | — |
| Category | Polymers | Polymers |
| Standard | IPC-4101 | ISO 527-1 |
Mechanical properties
| Property | FR-4 (Glass Epoxy Laminate) | PEEK GF30 | Unit |
|---|---|---|---|
| Flexural Strength | 380–480 | — | MPa |
| Tensile Strength | 280–340 | — | MPa |
| Compressive Strength | 350–420 | — | MPa |
Compatibility Assessment
FR-4 (Glass Epoxy Laminate) and PEEK GF30 have significantly different compositions (0% overlap). These materials are not interchangeable and serve different application areas.
Automated assessment based on composition analysis
Frequently Asked Questions
Is FR-4 (Glass Epoxy Laminate) the same as PEEK GF30?
FR-4 (Glass Epoxy Laminate) and PEEK GF30 have a 0% composition overlap. They are generally not directly interchangeable.
Can I replace FR-4 (Glass Epoxy Laminate) with PEEK GF30?
Generally not recommended. The compositions differ significantly (0% overlap). These materials have different alloying concepts and are intended for different applications.
What is the difference between FR-4 (Glass Epoxy Laminate) and PEEK GF30?
The main differences are in the following elements: overall alloying content. FR-4 (Glass Epoxy Laminate) is a Polymers grade, while PEEK GF30 is a Polymers grade.
View full data for each material:
Data provided for reference only. Always verify against the applicable specification for critical applications.
All data is for reference only. Equivalents indicate similarity, not identity. Always verify against the applicable specification for safety-critical applications. materialref.com accepts no liability for decisions based on this data.